upperdots

gears

bigadvantagecontactengineerrequestquote


FMS Corporation
Powder Metal Division
Tel.: +1 952-888-7976
Fax: +1 952-888-7978
info@fmscorporation.com

© 2017 FMS Corporation.
All rights reserved.

corner

In-Process Inspector

SUMMARY

Inspects powdered metal parts for dimensional accuracy and surface defects by performing the following duties.

ESSENTIAL DUTIES AND RESPONSIBILITIES include the following. Other duties may be assigned.

  • In-process inspections.
  • Lot inspection as needed.
  • 1st article inspection as required by customer and/or internal requirements.
  • Measures dimensions as part.
  • Examines part for defects such as cracks, chip out and other visual defects.
  • Separates and marks defective part according to rework operation required.
  • Capability studies as needed.
  • Gauge calibration as needed.
  • Blueprint interpretation and consultation with personnel to assure quality of part.

Qualifications: 

  • Experience as an in-process inspector required.
  • Must be able to accurately measure parts, read and understand blueprints, use various inspection equipment and instruments and operate a micrometer.  Must be extremely precise with measurements up to four (4) decimal points.
  • High school diploma or equivalent required.

Submit an application > 

rightcornerleftcorner
Careers | Privacy Policy | Site Map